Rear Brake Light Bulb Replacement Sedan
by: ccollantes
Background:
Replacing rear brake light (passenger side)
Tools:
- small scissors
Parts:
- 1122 Dual filament bulb
1. Cut stitches on the top and bottom of the access panel. Use a small scissor and be careful not to cut anything else aside from the stitches.
2. Open the panel to gain access
3. Release holding brackets then pull the assembly out. Take caution on the bulbs. For me, I had to pull the upper portion of the carpet a bit to make more room while pulling it out.
4. Once the assembly is out, replace worn out bulb. I bought the bulb from the dealer since my local Canadian Tire store didn’t carry it. Bulb type is 1122 from GE (dual filament).
5. To put it back, just reverse the procedure
page revision: 3, last edited: 09 Jan 2011 20:45
