Program A Key Fob

Manually programing the remote control

It is possible to have a maximum of four remote controls for your car.

Programming the remote control

1. - Insert the master key into the ignition lock and switch on the ignition (Do not start the engine!)
2. - Lock the vehicle from the outside manually using the second master key or valet key.
3. - Press button A(unlock) or button C(lock) on the remote control one time and then wait at least two seconds.
4. - Press either button once again one time.
5. - Switch off the ignition and remove the key from the ignition lock.

The Manual programming procedure is complete. The remote control is functional again.

Notes

• you have only 30 seconds to perform steps 2 through 4.
• Each new key must also be programmed as described above.